Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Bellflower?
Spring repair in Bellflower typically runs $180 – $340 for one spring, and that’s the range we quote most often. A matched pair of springs, which is what most residential doors use, usually costs about twice that because both springs are almost always replaced together. Your written estimate sets the final price, and we give that estimate free.
Why the range instead of a single number? Because two doors that look identical from the street can carry springs of different wire gauge, length, and cycle rating. A technician has to measure the actual springs on your door before anyone can quote honestly. At Colonial Garage Door Repair, we measure first and quote second, so there are no surprises when the work is done.
Key Takeaways
- One spring: typically $180 – $340. A matched pair: about twice that.
- Most spring replacements are finished in a single visit.
- Springs are under extreme tension and should only be handled by a trained technician.
- Written estimates are free, and the estimate sets the price.
- We work on the door and the opener system in one visit, so you don’t schedule two contractors.
Spring Replacement Cost Breakdown (2026)
Here’s how spring work typically breaks down for Bellflower homeowners. These are estimated ranges for 2026, and they’re consistent with the rest of our pricing.
| Service | Typical Estimated Cost |
|---|---|
| Spring repair or replacement (one spring) | $180 – $340 |
| Matched pair of springs | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2200 |
| General garage door repair | $150 – $600 |
What pushes a spring job toward the top of that range? The biggest factor is spring type and size. Torsion springs, the kind mounted on a bar above the door, tend to cost more than extension springs that run along the sides, because they take more precision to wind and balance. Wire gauge matters too: a heavier door needs a heavier spring, and that spring costs more. If your springs are paired, you’re buying two, and the math roughly doubles.
What keeps it lower? A single extension spring on a lighter door, or a straightforward job where the cables, drums, and center bearing are all still in good shape. When we quote a spring replacement, we check those surrounding parts at the same time, because a new spring paired with a worn cable is a callback waiting to happen. Getting it right the first time is cheaper than fixing it twice.
What Affects Spring Replacement Pricing in Bellflower
- Spring type. Torsion and extension springs are different animals. Torsion springs generally cost more because they require precise winding and balancing, and not every door uses the same setup. We identify yours before quoting.
- Door weight and size. Bellflower has a lot of single-car and two-car garages built in different eras, and older doors are often heavier than they look. A heavier door needs a stronger spring, and stronger springs cost more.
- Whether you replace one or both. If one spring of a matched pair has broken, the other is usually near the end of its life too. Replacing both at once costs about twice the single-spring range but saves you a second service visit later.
- Related wear. Cables, rollers, and bearings take the same load as your springs. If any of them are frayed or worn, we’ll tell you honestly whether they need attention now or can wait. We don’t add work you don’t need.
- Door and opener brand. We’re trained on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment, which means we show up understanding your system instead of guessing at it. No wrong parts, no wasted visit.
- Access and parking. Tight driveways and crowded curbs can add time to a job. It rarely changes the price much, but it’s part of how we plan a visit.
A Safety Note Before Anything Else
Garage door springs store an enormous amount of energy. When a torsion spring lets go, it can do real damage to a person standing in the wrong place, and the tools used to wind one can injure an experienced technician if something slips. We don’t walk homeowners through replacing a spring themselves, and we’d rather you didn’t try. What you can safely do is look: a visible gap in a torsion spring, or an extension spring stretched out of shape, tells you it’s time to call. Leave the rest to a trained technician.
If your door won’t open, or you heard a loud bang from the garage, stop using the opener. Forcing a door with a broken spring can bend the panels and turn a spring job into a panel job. Call (833) 598-2561 and we’ll get someone out. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday.
How Spring Replacement Works on a Typical Visit
A spring replacement isn’t complicated when it’s done right, and the steps are consistent. The technician secures the door, measures the existing springs, and matches replacements to your door’s actual weight and track setup. Old springs come off, new ones go on, and the door gets balanced and tested through a full open and close cycle. Then we check the opener’s travel limits and force settings so the drive system isn’t fighting the new springs.
That last step is where a lot of jobs go wrong elsewhere. A new spring changes how the door feels to the opener. If nobody adjusts the opener afterward, it can strain the motor or reverse when it shouldn’t. Because we service both the door and the opener system, we handle that in the same visit. Your door. Your opener. One call.
Most spring replacements are done in one visit. If the job turns up something else, like a worn cable or a bent track, we’ll explain it and quote it before we touch it. You decide what gets done.
How to Save on Spring Replacement
Spring replacement isn’t the place to chase the lowest bid. A cheap spring with the wrong cycle rating will fail early, and you’ll pay twice. That said, there are sensible ways to keep the cost down.
- Get a written estimate first. Any reputable company will quote before starting. Ours is free, and the written estimate sets the price.
- Replace a matched pair together. Yes, it costs about twice the single-spring range. But two separate visits cost more than one visit for a pair, and the second spring usually fails not long after the first.
- Handle related wear in the same visit. If your cables or rollers are close to failing, doing them during a spring job avoids a second dispatch later.
- Ask about spring cycle rating. A higher-cycle spring lasts longer. Ask what you’re getting and decide whether the upgrade makes sense for a door you use every day.
- Don’t run the opener on a broken spring. Every cycle with a broken spring puts strain on the opener. Catching it early protects the motor.
Nobody likes a surprise bill, so we quote in writing before we start and explain what each line is for. If something can wait, we’ll say so. Call (833) 598-2561 for a free estimate.
Repair or Replace? A Quick Way to Decide
If only the spring has failed and the door panels, tracks, and opener are sound, repair is the clear answer. Replacing a whole door when a $180 – $340 spring job would fix it doesn’t make sense. New door installation typically runs $700 – $2200, so that’s a much bigger decision.
Replacement starts to make sense when the door itself is failing: cracked panels, a bent track that can’t be straightened, or an opener so old that parts are hard to source. If you’re weighing that, we’ll give you a straight comparison between repairing what you have and installing new. We install doors from Clopay, Amarr, Wayne Dalton, and Raynor, so you’re not pushed toward a single brand. We tell you what we’d do if it were our own garage. Sometimes that’s a repair. Sometimes it’s a new door. Either way, you’ll hear the reasoning.
Why Bellflower Homeowners Call Colonial
We’re garage door specialists, not a general handyman service and not a side offering from another trade. Our three services are garage door repair, garage door opener repair, and garage door installation. That focus is why we can diagnose a spring problem, a cable problem, or an opener problem without guessing.
We’re factory-familiar with eight of the most widely installed brands in North America: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That matters when your opener is a Genie and the technician who shows up only knows LiftMaster. Brand-specific knowledge means the right parts on the first visit. We’ve been serving Bellflower since 2013, and we’ve built our reputation on doing the job once and doing it right.
FAQs – Spring Replacement Cost
How much does garage door spring replacement cost in Bellflower?
Expect $180 – $340 for one spring, and about twice that for a matched pair, which is what most residential doors need. Torsion springs and heavier doors sit near the top of that range; a single extension spring on a lighter door sits near the bottom. Call (833) 598-2561 for an exact quote, because the written estimate sets the price and estimates are free.
Should I replace both springs if only one broke?
Usually yes, and the cost is about twice the single-spring range. Springs in a pair are installed together and wear at nearly the same rate, so when one breaks, the other is typically close behind. Replacing both in one visit costs less than two separate visits, and it saves you the second breakdown. We’ll tell you if your setup is different.
Can you replace a spring the same day?
Often yes. Spring replacement is a single-visit job in most cases, and we carry springs in common sizes. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (833) 598-2561 and we’ll give you a clear time window.
Why is my spring quote higher than others I’ve seen?
Because a real quote is based on your actual door, not a phone estimate. Spring size, wire gauge, torsion versus extension, and door weight all change the price, so a range of $180 – $340 for one spring is honest where a flat price quoted blind isn’t. We measure before we quote. Our written estimate sets the final price, and there’s no charge for it.
Can I replace a garage door spring myself?
No. Garage door springs store enough energy to cause serious injury, and the winding process is where experienced technicians get hurt when something slips. A visible gap in a torsion spring or a stretched extension spring means it’s time to call a professional. Don’t run the opener on a broken spring either; you can bend panels and turn a spring job into a bigger one. Call (833) 598-2561.
Get a Free Spring Replacement Estimate in Bellflower
If your door won’t open or you’ve spotted a broken spring, the sooner it’s handled, the less chance of damage to your opener or panels. Call (833) 598-2561 for a free estimate on spring replacement in Bellflower. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed Saturday. When we arrive, we’ll measure your springs, explain exactly what’s needed, and quote it in writing before any work begins. No guesswork, no upselling, just the repair your door actually needs.
Pricing reflects the Bellflower market as of 2026. Colonial Garage Door Repair offers free estimates – call (833) 598-2561.
Written by the team at Colonial Garage Door Repair, serving Bellflower since 2013.
What Our Customers Say
"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Bryce Schaefer"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
- Brandon Kim"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Sarah Quinn